TPU/PLA Bike Chainstay Protector [Designed for Aventon Level 2]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D-printable 26mm chainstay protector for Aventon Level 2 e-bike. TPU works best; PLA requires heating. Protects paint.
- Ocena
- 0 / 5
- Polubienia
- 48
- Pobrania
- 199
- Wydruki
- 1
- Wyświetlenia
- 1992
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I designed this printable chainstay protector for my Aventon Level 2 e-bike because the bike does not come with one. After just two rides, I noticed that the chain was damaging the paint on the chainstay. The Aventon Level 2 has a very narrow chainstay, making it difficult to install many rubber protectors available on the market. Therefore, I created this slimmer version (26mm wide) that can be installed using double-sided tape of the same width.
I printed this protector using orange TPU and, after a month of riding, it has performed excellently. It has protected the frame's paint and shows no signs of coming off.
While PLA is not recommended for this protector, it is possible to use it. Attach double-sided tape to the back of the protector, stick one end to the frame, and then carefully use a hairdryer or heat gun to soften the PLA. This will allow you to mold the flat protector to the shape of the chainstay. During installation, wear heat-resistant gloves and exercise caution to avoid burns.