RPI Zero W2 - FLIRC Case - Piggy back mount for Prusa i3mk3s
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
"Piggy back" mount for Raspberry Pi Zero 2 in aluminum FLIRC case to attach to Prusa i3 mk3s Einsy cover.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 1245
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This "Piggy back" mount allows you to attach a Pi Zero w2 enclosed in a Flirc aluminium case directly on to your Prusa mk3s+ Einsy cover. The Pi is connected to the Einsy board with 4 wires (+5, 0, Tx, Rx).
The mount attaches to the Stock Einsy cover with four zipties.
The only pheripherals I use with the Pi is a low powered webcam and the 5V regulator on Einsy seems to be able to handle it well. I do not take responsibility if your setup would destroy your Einsy.
Remember to shut down your RPI from Octoprint before turning off your Prusa.
Enjoy!
Other components for installation:
4 x M3x6mm or similar screws.
4 x Zipties
1 x connecting cable (4 lead dupont female to female)
1 x right angle pin header spacing 2.54mm/0.1'' protruding min. 11.5mm. (I made one from the longest pins in a 3-row right angle 2.54mm PCB connector/pin header).