RPI Zero W2 - FLIRC Case - Piggy back mount for Prusa i3mk3s
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
"Piggy back" mount for Raspberry Pi Zero 2 in aluminum FLIRC case to attach to Prusa i3 mk3s Einsy cover.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 28
- Makes
- 1
- Views
- 1,245
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
This "Piggy back" mount allows you to attach a Pi Zero w2 enclosed in a Flirc aluminium case directly on to your Prusa mk3s+ Einsy cover. The Pi is connected to the Einsy board with 4 wires (+5, 0, Tx, Rx).
The mount attaches to the Stock Einsy cover with four zipties.
The only pheripherals I use with the Pi is a low powered webcam and the 5V regulator on Einsy seems to be able to handle it well. I do not take responsibility if your setup would destroy your Einsy.
Remember to shut down your RPI from Octoprint before turning off your Prusa.
Enjoy!
Other components for installation:
4 x M3x6mm or similar screws.
4 x Zipties
1 x connecting cable (4 lead dupont female to female)
1 x right angle pin header spacing 2.54mm/0.1'' protruding min. 11.5mm. (I made one from the longest pins in a 3-row right angle 2.54mm PCB connector/pin header).