1 / 1
XRP Robot-balloon kit
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a funny way upgrade to make this robot a battlebot!
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 672
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
Parts to Print:
- 1 x Stand lock
- 1 x Balloon stand
- 2 x Toothpick holder
Required Items for Enhanced Stability
- 2 x M3 screws (5mm)
- 2 x M5 screws (15mm)
Additional Items:
- 1 x Balloon
- 2 x Long toothpicks
- 1 x Cable tie
Installation Steps:
Toothpick Holder:
Insert the Toothpick Holder:
- Insert the toothpick holder into the hole located in front of the robot.
Insert the Toothpicks:
- Insert the toothpick through the holder. Ensure it is aligned properly.
Remove the Steel Ball:
- Remove any steel ball present in the assembly area.
Insert the M5 Screws:
- Insert the M5 screws (15mm) into the designated hole under the robot until the screw touches the toothpick to lock it in place.
Repeat for the Second Toothpick Holder:
- Perform the same steps for the other toothpick holder.
Balloon Stand:
Insert the Stand Lock:
- Insert the stand lock into the hole located at the center of the balloon stand.
Press Fit the Balloon Stand:
- Press fit the balloon stand into the back of the robot where the hole is located.
Insert the M3 Screws:
- Insert the M3 screws (5mm) into the two holes located in the front and back of the balloon stand.
Mount the Balloon:
- Inflate the balloon and lock it in place with the cable tie.