1 / 1
XRP Robot-balloon kit
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a funny way upgrade to make this robot a battlebot!
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 35
- Makes
- 0
- Views
- 672
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
Parts to Print:
- 1 x Stand lock
- 1 x Balloon stand
- 2 x Toothpick holder
Required Items for Enhanced Stability
- 2 x M3 screws (5mm)
- 2 x M5 screws (15mm)
Additional Items:
- 1 x Balloon
- 2 x Long toothpicks
- 1 x Cable tie
Installation Steps:
Toothpick Holder:
Insert the Toothpick Holder:
- Insert the toothpick holder into the hole located in front of the robot.
Insert the Toothpicks:
- Insert the toothpick through the holder. Ensure it is aligned properly.
Remove the Steel Ball:
- Remove any steel ball present in the assembly area.
Insert the M5 Screws:
- Insert the M5 screws (15mm) into the designated hole under the robot until the screw touches the toothpick to lock it in place.
Repeat for the Second Toothpick Holder:
- Perform the same steps for the other toothpick holder.
Balloon Stand:
Insert the Stand Lock:
- Insert the stand lock into the hole located at the center of the balloon stand.
Press Fit the Balloon Stand:
- Press fit the balloon stand into the back of the robot where the hole is located.
Insert the M3 Screws:
- Insert the M3 screws (5mm) into the two holes located in the front and back of the balloon stand.
Mount the Balloon:
- Inflate the balloon and lock it in place with the cable tie.