1 / 5
Team Associated B6.x, B7, B74.x rear pin shims — zdjęcie 1
1 / 5

Team Associated B6.x, B7, B74.x rear pin shims

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I recently lost a shim in the grass at the track when changing the toe, turns out you'd have to buy brand new rear…

Ocena
0 / 5
Polubienia
11
Pobrania
82
Wydruki
0
Wyświetlenia
371
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

I recently lost a shim in the grass at the track when changing the toe, turns out you'd have to buy brand new rear arms to get more plastic shims!! so I designed these. The kit ones are 2mm, so if you want replacements, then print a load of 2mm, however I did create some others ranging from 1.5mm up to 4.

They should fit B6, B6.x, B7, B74.x and probably loads of others too. They were a good fit for me however this can vary from printer to printer! So may need some light sanding.

One thing I'd say, its worth taking note is the layer height e.g. if you want 2mm then make sure you use something like 0.2mm, if you use something like 0.28mm then it'll either be too thin or too thick. Likewise, for the 1.5/2.5mm, if you use 0.2mm it'll be too thin or thick as you'll either end up with 1.4 or 1.6 depending on your slicer, I always ended up with less.

Category: R/C Vehicles

Tagi