SimpleHuman Soap Dispenser Lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement lid for the SimpleHuman soap dispenser.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 62
- Wydruki
- 1
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
While refilling the SimpleHuman soap dispener, the lid slipped through my fingers, fell to the ground and shattered to pieces…
Question:
Should I buy a replacement part or design my own lid? After reseaching the price for an original lid (11,95€ + 9,95€ shipping), I had my answer.
With the design I went a complete different route, than the original lid. The goal was, that it's as easy to print as possible and because of that I refused to use a dome style design.
The only thing you need from the original lid is the O-ring / gasket.
My Print Settings:
Rafts:
No
Supports:
Yes (Organic supports for the O-ring's deepening with 2mm distance to the model)
Resolution:
0.2
Perimeter:
4
Infill:
15%
Top and bottom pattern: concentric
Filament:
Extrudr PLA NX2 anthracite
Note:
I'm not sure, if PLA is the best choice to use with soap. Perhaps you should better use PETG.