PETamentor2 Utility Knife Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple adapter for the bottle cutter from the PETamentor2 to use a 9mm utility knife blade.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 61
- Wydruki
- 1
- Wyświetlenia
- 463
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple adapter for the PETamentor2, which enables you to use a 9mm utility knife blade to cut bottles if you don't have the ability to sharpen the edges of the two bearings used in the original design by Matthieu SAMSON.
For this design, you need the following hardware:
- 9mm utility knife blade
- 2x M8 nuts
- 2x M8 washers
- 2x M8x40 screws
- 5x wood screws, diameter 4mm, length 15mm
- 4x M3x10 screws
- 1x M8x50 screw with an 8mm notch
- 1x M8 nut
- 3x M3x10 screws
- 3x M3 nuts
- 1x Original PETamentor cutter motor
The adapter is simply pushed onto the two 40mm screws and is secured by the two M8 nuts.
Print without support and simply slide the blade under the two holding arms. Make sure that the blade is also secured by the two washers on either side.