Key Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Key Organizer to hold up to 4/5 Keys. Simple to print.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 1018
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Key Organizer to hold up to 4/5 keys.
Simple to print.
Use no brim, 0.2mm layer height, 100% infill, 0.4 nozzle, and check for good print adhesion.
2x M2x4x3.2 threaded insert is needed.
1x M3x5.7x4.6 threaded insert is needed.
2x M2x6 countersunk screw
1x M3x6 countersunk screw
1x extended spring (I have used 4.5x44.5, but the spring can vary depending on the pressure wanted).
Assembly
1: Print out the parts; check the images for print orientation.
2: Place the threaded inserts with a soldering iron. ! Be very cautious, as there are very thin walls! Try to come straight and not melt any walls.
3: Put the spring mechanism in its place, then the keys, and now install the spring. This process is a little tricky, as you need to hold everything in place while moving on to the final step.
4: Put the closure in place and start placing the upper piece. Once everything is placed, use the 3 screws to fix it.