6 in (six inch; 6") magnetic duct (vent) union couplers, with sealing cap and wall connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
6 in (six inch; 6") magnetic duct union couplers, with sealing cap and wall connector
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 784
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a set of magnetic couplers to temporarily attach six-inch (6in aka 6") flexible ducting in a way that is easily removable or transferrable between different flow paths. These are suitable for various applications, including: dust collection (conductive filament suggested); fume extraction for soldering, painting, or 3D-printer enclosures (avoid flammable vapors or solvents that could attack the print material), ventilation for humidity/temperature control of indoor vegetable gardens, or odor removal from minor nuisances like cat litter boxes.
Flexible ducting can be attached to the couplers with screw-drive pipe clamps, zip-ties, or other constricting fasteners.
The couplers feature annular “crenels” and “merlons” to help keep unions together, and the main mating surfaces have recesses to hold a series of 60x10x3mm rectangular rare-earth bar magnets (magnets I used).
The couplers will self-align better if the magnets alternate polarity. One easy way to get the magnet polarity right across several couplers is to take a stack of magnets and mark one pole across all of them (Sharpie marker works well and can be removed with IPA after the magnets have been installed), then install the magnets so all raised areas ("merlons") on all couplers have the same pole facing out, and all lower areas (“crenels”) have the opposite pole facing out (see photos). The magnets should be glued in place using something like cyanoacrylate glue or epoxy).
The couplers have a dovetail channel near the airflow path that can optionally receive a length of O-ring cord to improve the seal between couplers. It is designed to accept nitrile rubber O-Ring Cord Stock, 70A Durometer, 0.188'' (3/16" Actual) diameter (product I used). Directly pressing in the O-ring cord is difficult or impossible, but if the cord is stretched slightly it can be easily pushed into the channel (allow adequate extra length for retraction once installed). The cord should be bunched up once in the channel so it protrudes adequately to make a seal. Adjustment to printer tolerances may be needed to ensure a good seal.
In addition to couplers that can connect ducts, a sealing cap is also included, as well as a basic solid union, and a screw-mount ring so a duct coupler can be mated to a hole in the sidewall of a box or tool.
The “improved” version includes small protrusions to assist in separating the couplers once attached.
The couplers can be printed with without supports, with the mating surfaces facing up. A brim should not be necessary. Multiple perimeters or high infill recommended so the thinnest walls have a solid cross-section.
Important: These are probably not compliant with any building or safety codes. Do NOT use for permanent installations, in commercial or industrial settings, and if printing in plastic, for safety do NOT use in applications where the couplers may be exposed to grease, fire, or hot air (i.e. do NOT use these for kitchen vent exhaust, do NOT use for clothes dryer exhaust).