USB-C PD adapter for Duux Whisper 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slot-in replacement to upgrade the cost-effective duux Whisper 2 to USB-C
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Rev.2
V2 Doubles the thickness of the little arm holding the PCB in place, giving it some more heft, as it broke for me after a few plugging cycles. I will also print the next version in ABS.
Rev.1
This handy dandy adapter piece slots into the same spot that the duux Whisper 2's Barrel jack originally goes into. It has the exact dimensions to fit one of these PD boards: https://de.aliexpress.com/item/1005006068684294.html
It will however make the bottom shell's fit a little tight, and I think the part and the board is under a bit of stress when reassembled because it is a lot longer than the original part. I have however used it for quite a bit now, and also under sustained load, and the board seems to handle it well. I have not done any thermal testing, but I can say that the fan at full blast including one of the oscillation modes will draw just about exactly 20W, so somewhere in the neighborhood of 2A should be the max. power draw for the fan.
The boards are advertised to handle up to 5A, but with a little china tolerance they should handle everything up to 3A sustained just fine.
I printed this in PLA and had no problems, though for the long run, ABS/ASA is probably your better choice.
Easy print. No support, minimal bridges.
Print with the little arm on the bed side