Silica Box with Filament Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a silica gel box with filament holder, you can use it to make your dry box for printing. Box: 17cm x 20cm.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
You can print these two boxes to put your silica inside and support your roll of filament.
The volume of silica is exaggerated as I only use one box for printing (one filament at a time).
You will need to dry your silica from time to time.
I printed it on wet PETG, the quality wasn't good (lots of webs), but it can be printed on PLA, ABS or other material.
The gap has enough space to prevent the 1.5mm silica from passing through.
It is recommended to measure the box you are going to use, but I designed it to use a box measuring 17cm wide by 23cm deep.
The filament rolls free in the middle, you can improve by using standard rolls (make a support with bearings that fits into the hole of the filament roll).
For the filament roll, you need a bar or pipe that is loose, I used a standard 30mm pipe in Brazil. You can print it too.