1 / 3
SLYNX 2.1 - Linear Rail Mod (Remixed from ZAX's LONX mod) — zdjęcie 1
1 / 3

SLYNX 2.1 - Linear Rail Mod (Remixed from ZAX's LONX mod)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adds a linear rail assisted prime to the Slynx 2.1, remixed from ZAX's lonx files.

Ocena
0 / 5
Polubienia
16
Pobrania
74
Wydruki
1
Wyświetlenia
817
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

9/7/24: 

  • Reuploaded the correct thicc pump files.

29/6/24: 

  • Added the top pump for MGN9H rail (I've only tested for C rail, should work the same regardless). 
  • Added a shroud base that works with the older lynx receiver without the interlocking bits.
  • Added alternate top pump assemblies which are slightly thicker. Print this if the default pump is breaking around the front.

Refer to the original mod by ZAX for assembly instructions.

However for the pump use the following metric hardware:

  • M4 x 8mm screws
  • M4 nuts
  • 6 x 7mm ball detent (optional)

I've not tested with lock washers, but you'll most likely need M4 x 10mm instead.

Tagi