Garmin Panoptix/Livescope Ice mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ice fishing stand for 6" or 8" hole
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 1869
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM
STAND
(2) ¼-20 SHCS 3" partially threaded
(1) ¼-20 SHCS 1" Partially threaded
(4) 10-32 3/4" Flatheads (Sharpened to point - optional)
COLLAR
(2) 6-32 SHCS ¾" Fully threaded
BUILD
STAND -Install one ¼-20 SHCS 3" and tighten until both parts are drawn together flush, install other 3" SHCS, followed by the 1" SHCS.
COLLAR -Mount collar on pole with 6-32 SCHS. Collar should be installed above ice thickness with radius edge facing down.
Stand will float (axial) on the pole and allow for 360 degree rotation while held by the collar.
The 10-32 screws sharpened are used to keep the stand from freezing to the ice. I did not use them, but it is an option.
NOTES
This is designed for a 6" diameter hole, it will work with an 8" hole.
I used a fiberglass handle from a broken shovel as my pole. Don't use wood as it has a better chance of floating, absorbing, and expanding with water through temperature change.
Pole diameter is 1.26"
Collar ID: 1.26" with slots separated by .15"
Stand ID: 1.28"
This was printed in halves due to the Prusa Mini's size.