BTT HDMI 7 case 2020 extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the BTT HDMI 7 with a joint and base plate for printers with 2020 extrusions. The case is designed to be printe
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 254
- Wydruki
- 2
- Wyświetlenia
- 1227
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Description
Case for the BTT HDMI 7 with a joint and base plate for printers with 2020 extrusions. The case is designed to be printed in one piece. Case and base are original while other parts are reused or remixed from the two models linked below.
Files
Screen case : original
Joint : Jake90's joint model remixed for heatset inserts
Knob : COD's knob model
Base : original
Button : original but inspired
BOM
4* M3x4x5 heatset inserts
8* M3x10 button head screws (for the joint anything longer than 10mm will work, but use button head only)
1* M8x40 hex bolt
1* M8 hex nut
2* M5x12 screws
2* M5 T-nuts
Instructions
Secure the heatset inserts in the joint
Screw the joint to the case using M3x10 screws
Insert the buttons in their holes
Slide in the screen, be careful with the ribbon cable
Screw the screen to the case
Setup the base on your frame
Screw the joint to the base
Printing settings
Printed mine with PLA and works just fine
0.2mm layer height (forced on first layer too), at least 3 walls and 3 bottom/top layers.
Most files can be printed without any supports. Except for the screen case which was designed to be printed in one piece and vertically. The only supports required are the one to support the bridging like shown in the picture.
Check out my other ZeroG Mercury1 mods