1 / 2
Fishing Pole Garage Storage -- REV 2 OUT NOW ON MY PROFILE — zdjęcie 1
1 / 2

Fishing Pole Garage Storage -- REV 2 OUT NOW ON MY PROFILE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This design is to store fishing rods on the back of a garage door and keep them out of the way when the door moves

Ocena
4,857 / 5
Polubienia
224
Pobrania
773
Wydruki
9
Wyświetlenia
5880
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

NOTE: REV 2 AVAILABLE HERE --> https://www.printables.com/model/1709622-fishing-pole-garage-door-hanger-rev2

  • BETTER CLEARANCE WITH HINGE PIN

  • OPTIMIZED SPACING FOR SPINNING REELS

  • OPTIMIZED SIZING FOR STANDARD 256mm BED SIZES

This is my first model for Printables.  We have several sets of fishing rods in our family and needed somewhere safe to store them.

The clip for the garage door hinge is sized for a 15mm hinge diameter, this may need to be modified to your specific door.

I recommend using the two pole variant for fly rods or spinning rods. The three pole variant works well for spinningcast and baitcast equipped rods.

So far tested with PETG using 0.2mm layer height, 3 walls, 3 top/bottom layers, and 15% grid infill.

Can fit one set (two hangers) on a 180mm bed if you rotate each hanger by 15 degrees.  Printed on a Bambu A1 mini.

Tagi