1 / 24
Belted Ender by squirrelf - Club edition - Z rails support + STEP files — zdjęcie 1
1 / 24

Belted Ender by squirrelf - Club edition - Z rails support + STEP files

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Self tensioned belts using springs, wheels or z rails, STEP file Support ender 3/pro/v2 and similar frames

Ocena
0 / 5
Polubienia
10
Wydruki
0
Wyświetlenia
475
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables

STL, notes and BOM is in the zip.

Latest zip (September 8 2024) has linear rail version as well

if you need a printed GT2 80t pulley click here

One working and tested novelty here is a self tensioning system using a spring ( two specific spring were tested, can be found on Amazon or aliexpress, see BOM ). and belt had excellent tension and both matched each other within 1hz
15mmx8mm yellow and red spring have been tested and work great

This supports two major setup:

  • Individual Z , requires 5 stepper drivers for Z-tilt 

or

  • Mechanically linked Z (this wan't actually tested but should work fine)
    Motors can share a stepper (or still have individual ones, which is technically better). 
    In theory this can run also on a single motor, but not sure if in practice that would work ( both regarding holding the X axis while motor are  powered off or if there could be some mechanical lag between the two Z )


Different axle and bearing size options.


In term of hardware there are a few options like 5mm lower axis or 8mm lower axis in case you have some of the hardware in hand already.
 

later will support ender3max frame style which is a bit different from ender3 “normal” series.

I tested it on ender3v2 so no PSU in the way, but for ender3 and 3pro you will need to find a way to relocate the PSU or shift it further back

This is also available on my patreon.com/squirrelf3d

Tagi