Belted Ender by squirrelf - Club edition - Z rails support + STEP files
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Self tensioned belts using springs, wheels or z rails, STEP file Support ender 3/pro/v2 and similar frames
- Rating
- 0 / 5
- Likes
- 10
- Makes
- 0
- Views
- 477
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
STL, notes and BOM is in the zip.
Latest zip (September 8 2024) has linear rail version as well
if you need a printed GT2 80t pulley click here
One working and tested novelty here is a self tensioning system using a spring ( two specific spring were tested, can be found on Amazon or aliexpress, see BOM ). and belt had excellent tension and both matched each other within 1hz
15mmx8mm yellow and red spring have been tested and work great
This supports two major setup:
- Individual Z , requires 5 stepper drivers for Z-tilt
or
- Mechanically linked Z (this wan't actually tested but should work fine)
Motors can share a stepper (or still have individual ones, which is technically better).
In theory this can run also on a single motor, but not sure if in practice that would work ( both regarding holding the X axis while motor are powered off or if there could be some mechanical lag between the two Z )
Different axle and bearing size options.
In term of hardware there are a few options like 5mm lower axis or 8mm lower axis in case you have some of the hardware in hand already.
later will support ender3max frame style which is a bit different from ender3 “normal” series.
I tested it on ender3v2 so no PSU in the way, but for ender3 and 3pro you will need to find a way to relocate the PSU or shift it further back
This is also available on my patreon.com/squirrelf3d