GT2 timing belt equal length checker and cutting helper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little tool to keep two lengths of GT2 timing belt aligned to help cut exactly in half or match an existing length.
- Ocena
- 4,5 / 5
- Polubienia
- 29
- Pobrania
- 170
- Wydruki
- 3
- Wyświetlenia
- 731
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Sandwich the lengths of belt together, teeth facing each other. Use the marks on top as a visual guide/reminder to decide which length of belt has the leading tooth - this is important when deciding where to cut if you need exact matching tooth count. As you pull the belts through together, the teeth stay interlocked, allowing you to check or cut to equal length even over several metres.
Accepts two M6x12 cap head screws to fix to your printer frame with suitable T-nuts during a build (this is typical RatRig hardware). Or you can clamp it in a vice.
Tested with 9mm belt, other widths should be fine.
Printing
Any non-flex, smooth material (PLA is fine). 4 or more perimeters, 25% infill. Tested with 0.2 layers and 0.4 nozzle.
There are two variants. One has extra “wings” you can use as a cutting surface.