Vintage Carbon Microphone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A vintage carbon mic, used onstage. This is NOT a functional microphone - it is a prop. Threaded to fit a mic stand.
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 210
- Wydruki
- 1
- Wyświetlenia
- 1281
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution
A vintage carbon mic, used onstage. This is NOT a functional microphone - it is a prop. This has a threaded base, that screws on to a standard microphone stand (5/8"-27) and fits nicely. The front and back halves are glued together, and the ring is glued to the base. The springs were purchased at a hardware store. The whole thing was then painted. Modeled in Fusion 360.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
No
Supports:
Yes
.2
Infill:
15%
Notes:
I did use supports under the little rings on the inside of the big ring. Just a basic PLA - I often use Hatchbox, but I am not sure what brand I used.
Category: Props