Happy Plant Support / Plant Stake / Pflanzenstab
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stackable plant support. 21cm height for the base and 18cm for the add-on.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 441
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Finally!
The first print my wife asked for after 2 years of printing :) I made it!
Jokes aside. This was a request by my wife with special requirements as you can see.
Due to my small printing plate I had to model 2 different pieces which you can stick together.
I used Jevers base stick as foundation for my model. I could have modeled my own but I was to lazy to be honest.
My wife's happy and I can continue my printing journey ;)
I used a 0.4n with a 0.16mm LH and 70 PS on a Neptune 3.
Base model:
21cm height
13g
30% Infill (Grid)
1:22h
base model requires 6cm of width space in the pot for the support. The lower part has a length of around 5cm. which should give enough stability in the pot-earth.
Add-On:
18cm height
22cm width
18g
30% Infill (Grid)
2:14h
The Add-On can be put on top of the base model.
Happy printing!