1 / 2
Magnetic whiteboard marker holder (20x5mm magnets) — zdjęcie 1
1 / 2

Magnetic whiteboard marker holder (20x5mm magnets)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic marker holder for 5 markers (Pilot V-Board Master)

Ocena
0 / 5
Polubienia
5
Pobrania
59
Wydruki
0
Wyświetlenia
209
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remixed model for 5 markers. It uses two 20x5mm circular magnets. I used PLA, 0.2mm layer height, 0.4mm nozzle with gyroid 15% infill, magnets are glued by the CA glue.

Tip: Before printing make sure, that your magnets on the whiteboard are strong enough (often there is the steel base plate too far away from the front whiteboard surface) and it doesn't fall from the whiteboard by itself (happened to me). The holder holds itself on the whiteboard thanks to the aluminum edge (good enough for my use). When I tried another whiteboard it was holding completely fine without falling.

Tagi