1 / 2
Magnetic whiteboard marker holder (20x5mm magnets) — image 1
1 / 2

Magnetic whiteboard marker holder (20x5mm magnets)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Magnetic marker holder for 5 markers (Pilot V-Board Master)

Rating
0 / 5
Likes
5
Downloads
59
Makes
0
Views
209
Reviews
0

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution — Noncommercial — Share Alike

Remixed model for 5 markers. It uses two 20x5mm circular magnets. I used PLA, 0.2mm layer height, 0.4mm nozzle with gyroid 15% infill, magnets are glued by the CA glue.

Tip: Before printing make sure, that your magnets on the whiteboard are strong enough (often there is the steel base plate too far away from the front whiteboard surface) and it doesn't fall from the whiteboard by itself (happened to me). The holder holds itself on the whiteboard thanks to the aluminum edge (good enough for my use). When I tried another whiteboard it was holding completely fine without falling.

Tags