Sterilite (19L) Drybox (updated)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An update to my remixed drybox to fit a Sterilite 20Qt / 19L crate.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 560
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My first remix had individual rollers which worked well and enabled the use of any size spool, but in practice I found them frustrating to use and awkward to ensure they lined up with the spool.
This update has two large rollers per spool, fitting 4 spools up to 71 mm width in the Sterilite crate. Larger spools would just take up two spots in the drybox.
I have also included pass throughs for the PTFE tubes. These are angled to enable PTFE tubes to exist the side of the crate. To install the pass throughs, drill 0.5 in holes in the side of the crate. I used some silicone to seal the pass through in place, but it is probably not necessary.
Parts list
16x bearings 8mm ID x 22mm OD x 7mm thick (608-2Z)
2x 8mm (5/16in) rods (13 inches long each)
8x 6-32 x 0.5in socket head screws (to attach the PTFE pass throughs)