[AIRSOFT] VFC HK416A5 Magwell for PTS EMP
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magwell for VFC HK416A5 AEG version allowing the use of PTS EPM magazines without them being extra-wobbly
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 203
- Wydruki
- 1
- Wyświetlenia
- 1252
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
(Pardon my english, I am not a native speaker)
Tired of wobbly PTS mags in your magnificent 416 ?
Here is a solution !
This magwell will hold your mag in place and preventing it from oscillating from right to left into the pew's magwell.
------------------------------------------------------------------------
Printing advices
Stick the wider side (bottom) to the bed and enable supports for the “rails” visible inside the part.
I printed mine in ABS but I think other material will be suitable.
------------------------------------------------------------------------
Installation
Put the rear (open side) of the magwell against the pew's magwell and carefully widen the opening, allowing the piece to glide toward it's final position.
Be gentle, I broke some of my versions by applying to much strength. And pey attention to the “trench” on the left side of the pew, you will need to reopen the magwell a little bit.
Now you might have reached the end of the pew's magwell and each side of the printed piece should be in contact with each-other.
It might stay in place without any futher steps but you can secure it and adjust the retention of the mag by adding a M3x16mm SHCS and an adapted nut.
------------------------------------------------------------------------
ENJOY :)