[AIRSOFT] VFC HK416A5 Magwell for PTS EMP
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Magwell for VFC HK416A5 AEG version allowing the use of PTS EPM magazines without them being extra-wobbly
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 201
- Makes
- 1
- Views
- 1,242
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
(Pardon my english, I am not a native speaker)
Tired of wobbly PTS mags in your magnificent 416 ?
Here is a solution !
This magwell will hold your mag in place and preventing it from oscillating from right to left into the pew's magwell.
------------------------------------------------------------------------
Printing advices
Stick the wider side (bottom) to the bed and enable supports for the “rails” visible inside the part.
I printed mine in ABS but I think other material will be suitable.
------------------------------------------------------------------------
Installation
Put the rear (open side) of the magwell against the pew's magwell and carefully widen the opening, allowing the piece to glide toward it's final position.
Be gentle, I broke some of my versions by applying to much strength. And pey attention to the “trench” on the left side of the pew, you will need to reopen the magwell a little bit.
Now you might have reached the end of the pew's magwell and each side of the printed piece should be in contact with each-other.
It might stay in place without any futher steps but you can secure it and adjust the retention of the mag by adding a M3x16mm SHCS and an adapted nut.
------------------------------------------------------------------------
ENJOY :)