XRP Caster ( 1" / 25.4mm )
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fitting caster for the XRP
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
This is just a simple 1" / 25.4mm high res sphere used as a caster for the XRP.
I'm not acting like this was a lot of work, but with no model provided on printables I thought I share mine. It can also be easily achieved in every slicer, but usually that model would be quite low res.
If you wanna see a bit more complicated models check out my other models like the boat mod, the track system, the off-road mod or the big boy.
Print List:
- 2x caster
Print Settings:
It's intended to be a hard filament. Soft filament might cause too much friction in the mount. I would recommend using some organic support. Adding manual support on the model did not produce better results for me.