XRP Caster ( 1" / 25.4mm )
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fitting caster for the XRP
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 52
- Makes
- 0
- Views
- 171
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Public Domain
This is just a simple 1" / 25.4mm high res sphere used as a caster for the XRP.
I'm not acting like this was a lot of work, but with no model provided on printables I thought I share mine. It can also be easily achieved in every slicer, but usually that model would be quite low res.
If you wanna see a bit more complicated models check out my other models like the boat mod, the track system, the off-road mod or the big boy.
Print List:
- 2x caster
Print Settings:
It's intended to be a hard filament. Soft filament might cause too much friction in the mount. I would recommend using some organic support. Adding manual support on the model did not produce better results for me.