ESP32 Project Enclosure with OLED SSD1306 0.96"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made a project box for the ESP32 board with a lid for the 0.96" OLED screen. It houses multiple access points for access
- Ocena
- 5 / 5
- Polubienia
- 64
- Pobrania
- 1088
- Wydruki
- 1
- Wyświetlenia
- 5215
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Made a project box for the ESP32 WROOM (although most ESP32 boards have the same form factor), with a lid for the 0.96" OLED screen.
It houses multiple access points for wiring, and a small 10mm slot for the touch sensors. I use a folded piece of nickel strip used for soldering lithium cells, and wire it to a touch-enabled GPIO pin.
There's extra space in there for voltage regulators, IMU's, etc. as well as the touch sensors. The lid also has a spot for a single 5050 addressable LED.
I've added a shorter box, in case you just want access to the pins from the outside. Not sure how the OLED will work being so close, but the photo is just a demo of what it could look like.
Print as-is, even .25mm layers will do.