ESP32 Project Enclosure with OLED SSD1306 0.96"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made a project box for the ESP32 board with a lid for the 0.96" OLED screen. It houses multiple access points for access
- Rating
- 5 / 5
- Likes
- 64
- Downloads
- 1,088
- Makes
- 1
- Views
- 5,215
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Made a project box for the ESP32 WROOM (although most ESP32 boards have the same form factor), with a lid for the 0.96" OLED screen.
It houses multiple access points for wiring, and a small 10mm slot for the touch sensors. I use a folded piece of nickel strip used for soldering lithium cells, and wire it to a touch-enabled GPIO pin.
There's extra space in there for voltage regulators, IMU's, etc. as well as the touch sensors. The lid also has a spot for a single 5050 addressable LED.
I've added a shorter box, in case you just want access to the pins from the outside. Not sure how the OLED will work being so close, but the photo is just a demo of what it could look like.
Print as-is, even .25mm layers will do.