Cable drum from filament spool with slip ring and ball bearings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An overengineered cable drum from a filament spool. The wire cap can be found here: https://www.printables.com/model/950
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 380
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I needed a drum to roll 50 m of wire that can be unrolled while connected. The cable connects a tracked robot to the remote. So the robot pulls the cable while the other end of the cable stays connected to the remote.
Therefore I came with this solution:
- take a spare filament spool holder
- a slip ring and a piece of aluminum tube
- 2 ball bearings - I had a 6mm inner diameter and a 10mm inner diameter. Through the 6mm I inserted a M6 hex screw that acts as an axle and through the 10mm ballbearing I insterted the end of the slip ring.
- I also made a cover for the cables, just to make is safer
The 2 parts of the holder are held in position by 3 pcs of 4 mm x 50 mm wood screws.