Razor cover for Gilette skinguard sensitive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternative to the original Gilette skinguard sensitive transparent cover which is way too easy to lose.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 276
- Wydruki
- 5
- Wyświetlenia
- 811
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
I find the original transparent cover particularly useful when traveling.
I needed an extra one, so I took some measurements from the original little cover and I made a similar one.
I have used this piece for more than a year and it's still holding just fine, even the clips are working flawlessly.
I designed this model to work with Gilette Skinguard Sensitive blades, I don't know if it works even with other models, it would be cool.
Apparently @wildbillyho says that scaled at 97% the model works great with Mach3 blades.
I hope you'll find this model useful, and please post your makes! :D
Printing Instructions:
The model should be printed with the round holes facing the build plate so that no supports are needed.
I sliced the model in PrusaSlicer with 4 perimeters and 5 top/bottom layers, there's practically no infill, which by the way I set to 20%.
I set the layer height to 0.2 mm, but I used adaptive layer height to make the little tab more detailed (it's at about 7 mm of height).
The tolerances in the model are quite small, but I found out that printing it at about 40 mm/s gives a nice result that slides in just like it should.
The filament I used in the photos is Sunlu's transparent PLA+.