Razor cover for Gilette skinguard sensitive
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An alternative to the original Gilette skinguard sensitive transparent cover which is way too easy to lose.
- Rating
- 5 / 5
- Likes
- 36
- Downloads
- 276
- Makes
- 5
- Views
- 811
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
I find the original transparent cover particularly useful when traveling.
I needed an extra one, so I took some measurements from the original little cover and I made a similar one.
I have used this piece for more than a year and it's still holding just fine, even the clips are working flawlessly.
I designed this model to work with Gilette Skinguard Sensitive blades, I don't know if it works even with other models, it would be cool.
Apparently @wildbillyho says that scaled at 97% the model works great with Mach3 blades.
I hope you'll find this model useful, and please post your makes! :D
Printing Instructions:
The model should be printed with the round holes facing the build plate so that no supports are needed.
I sliced the model in PrusaSlicer with 4 perimeters and 5 top/bottom layers, there's practically no infill, which by the way I set to 20%.
I set the layer height to 0.2 mm, but I used adaptive layer height to make the little tab more detailed (it's at about 7 mm of height).
The tolerances in the model are quite small, but I found out that printing it at about 40 mm/s gives a nice result that slides in just like it should.
The filament I used in the photos is Sunlu's transparent PLA+.