Cycling Light Charging Valet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Valet to keep your cycling lights while charging
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Valet to keep your cycling lights organized when charging.
For more stability, I used the “add negative volume” feature in Prusaslicer to generate cylindrical voids inside the base and paused printing at the layer height of the top of the voids. Then I installed some heavy washers into the holes and resumed printing to trap the heavy washers inside the print. This made the base heavier than just using higher infill density.
There are 2 models, a base and a hanger. I printed the base with the bottom on the build plate and the hanger laying on it's side. The square hole in the base is a tight fit for the hanger and I have not found a need to glue the hanger in place.