KLR650 Water Pump Mechanical Seal Driver + Backing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple seal driver and backing support for installing a water pump mechanical seal into your KLR650 engine cover.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 234
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Simple seal driver and backing support for installing a water pump mechanical seal into your KLR650 engine cover. Designed to be used with a 5/16ths bolt. Be sure to use washers on the prints to spread out the load and use a high infill for good compressive strength.
Better than using a socket as it will prevent marring and the driver is designed only to interface with the lip of the seal. When used with the backing, it will keep the seal driver perfectly aligned with the bore and you'll be done with just a few quick turns of the wrench.