1 / 3
XL turbine with protection + mod for XL cover - Remix of Squeeze fan XL
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Differences to the originals in description. Replaces 1a and 2b of the original model. The rest is still required.
- Ocena
- 4,5 / 5
- Polubienia
- 106
- Pobrania
- 320
- Wydruki
- 3
- Wyświetlenia
- 2320
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 3) (Komentarze: 4)Remiksy (0)Kolekcje (105)Powiązane
I have used the following configurations in OrcaSlicer for the different models:
- Cover_XL_Mod (Replaces 2b of the original model): 75% cubic infill, no brim (I would recommend using it), layer height 0,2mm, width 0,42mm, 210/65ºC on first layer, 200/55 on following ones. Printing time for me was around 1h10min.
- Turbine_Circled_1LAYER (Replaces 1a of the original model): 20% cubic infill (less infill should work as well), the rest is the same. I have left supports in AUTO, and Orcaslicer did add supports. I think they are not needed, but I let them and the print was really good. Printing time was around 45min.
- Turbine_Circled_2LAYERS (Replaces 1a of the original model): I have not printed this model. Just increased the circle width from 0,4 to 0,85 to force the slicer to use 2 layers for strenght. I don't think it's necessary, but I can tell the 1LAYER model would be easy to break if the model falls to the ground or similar. Same settings that the ones used for 2.