1 / 3
XL turbine with protection + mod for XL cover - Remix of Squeeze fan XL
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Differences to the originals in description. Replaces 1a and 2b of the original model. The rest is still required.
- Rating
- 4.5 / 5
- Likes
- 106
- Downloads
- 320
- Makes
- 3
- Views
- 2,320
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
I have used the following configurations in OrcaSlicer for the different models:
- Cover_XL_Mod (Replaces 2b of the original model): 75% cubic infill, no brim (I would recommend using it), layer height 0,2mm, width 0,42mm, 210/65ºC on first layer, 200/55 on following ones. Printing time for me was around 1h10min.
- Turbine_Circled_1LAYER (Replaces 1a of the original model): 20% cubic infill (less infill should work as well), the rest is the same. I have left supports in AUTO, and Orcaslicer did add supports. I think they are not needed, but I let them and the print was really good. Printing time was around 45min.
- Turbine_Circled_2LAYERS (Replaces 1a of the original model): I have not printed this model. Just increased the circle width from 0,4 to 0,85 to force the slicer to use 2 layers for strenght. I don't think it's necessary, but I can tell the 1LAYER model would be easy to break if the model falls to the ground or similar. Same settings that the ones used for 2.