1 / 3
Drilling parts for swimming pool pipe fittings DN50 (2")
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drilling and holding part for probes and measuring sensors they going into a pipe of swimming pool
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 587
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (0)Kolekcje (39)Powiązane
2"/D50 pipe fitting for probe/sensor/injector holding onto pipe. It has been made with two typical pipe-threads - G1/2 and G3/4. You can look into my other models, where you can find temperature probe sensor shaft for this fitting or special fitings made for various pH/ORP probes.
Printing:
- material for both parts: PET/ASA/ABS
- both parts should be printed in vertical position
- support: Tree, touched build-plate with intra brim (5-8) and top-interface on (0.2mm)
- bridging: on, optionaly if you dont use support for threads/holes (recommended!)
- subsequently restore the thread shape with an appropriate tap after printing
Other material used:
- two hex (13mm) bolts M8x45 with nuts
- o-ring sealing 35x3.2