1 / 3
Drilling parts for swimming pool pipe fittings DN50 (2")
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drilling and holding part for probes and measuring sensors they going into a pipe of swimming pool
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 83
- Makes
- 0
- Views
- 587
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
2"/D50 pipe fitting for probe/sensor/injector holding onto pipe. It has been made with two typical pipe-threads - G1/2 and G3/4. You can look into my other models, where you can find temperature probe sensor shaft for this fitting or special fitings made for various pH/ORP probes.
Printing:
- material for both parts: PET/ASA/ABS
- both parts should be printed in vertical position
- support: Tree, touched build-plate with intra brim (5-8) and top-interface on (0.2mm)
- bridging: on, optionaly if you dont use support for threads/holes (recommended!)
- subsequently restore the thread shape with an appropriate tap after printing
Other material used:
- two hex (13mm) bolts M8x45 with nuts
- o-ring sealing 35x3.2