Advanced Filtration System Adjustable Exhaust (v3) for the Original Prusa Enclosure

Remixed the Advanced Filtration System Add-on Printable Parts to add a ducting and exhaust system that can be easily oriented to redirect airflow into or out of the enclosure

Features

• Easy to print and to assemble
  • All the printed parts Snap Fit to each other
    • No Super Glue or Hardware required
  • Use 4 nylon rivets to attach the exhaust_cover to the back acrylic panel
    • Use the spare nylon rivets provided with the Original Prusa Enclosure
• Exhaust can be easily oriented to redirect airflow into or out of the enclosure
  • Keeps the enclosure cooler while printing PLA (around 24.9°) or PETG (26.9°)
  • Keeps the enclosure warm while printing ABS or ASA
• Almost direct line ducting and better airflow  
  • Requires printing a Remix of the Advanced Filtration System Add-on 
    • Fan Rotated 90deg - Prusa Filtration System Housing Remix

Be advised

• This is a very tight fit, your printer and filament settings must be very well calibrated
  • On the safe side, try printing and test fitting seg0 and seg1 before printing all parts
• This has not yet been fully print tested, so let me know if you encounter any problems

If you liked this model

• Don't forget to post a make on Printables and/or Social Media

Special Thanks 

• Special thanks to Vespercorp and Pseudo
  • Without their collaboration this model would not exist

Print settings

• Print settings : Default 0.20mm STRUCTURAL
• Printer : Original Prusa MK4 Input Shaper 0.4 nozzle
• Filament : Generic PETG
• Perimeters : 2~3
• Support : None
• Brim : None
• Infill : 15%
• exhaust
  • Supports : Support on build plate only
  • Support style : Organic
• duct_seg
  • seg0
    • Inner Brim ONLY if you have a bad first layer or bed adhesion
  • seg(1,2,3,4)
    • Brim recommended if you have a bad first layer or bed adhesion
  • seg5
    • YES a Brim is required
  • seg6
    • NO Brim is required