Sweep LP Bottom Plate (Choc V1 Hotswap)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bottom plate for the Sweep keyboard that aims to be a super-minimal case when paired with rubber feet.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 434
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is bottom plate only case for the Sweep LP keyboard (choc v1 hotwap sockets). This takes inspiration from the TOTEM case that was remixed in TOTEM Redux. I printed the PCB from the GitHub repo, however it appears the same PCB can be found here.
The goal is have a super super minimal “case” that provides protection and some stability for the underside of the board.
There are two versions, one for the wired version with cutouts for the TRRS jack and another for the bluetooth version with cutouts for the power switch.
NOTE: This plate assumes a very specific orientation for the hotswap sockets. The longer end of the hotswap socket should be oriented toward the bottom of the board. Please reference the photos.
Hardware
- 8x 6mm M2 screws
- 8x M2 nuts
Could use a little bit shorter screws if available. The plate has small countersinks for certain screws.
Printing
Nothing special for the printing. I used both standard 0.2mm and 0.3mm layer height profiles in Orcaslicer.