Sturdy 10 inch rack mount for the TL-SG105E consumer network switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This sturdy 1U mounting panel for 10 inch server racks fits one TP-Link TL-SG105E 5-port, 1G, consumer network switch.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 211
- Wydruki
- 0
- Wyświetlenia
- 1360
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v3.0
-------------------------------------------------------------------------------------------------
UPGRADED PARTS AVAILABLE!
Click the link to get to V.2 of this part:
https://www.printables.com/model/1275345-celestes-sturdy-10-rack-mount-panel-v2-for-tl-sg10
-------------------------------------------------------------------------------------------------
Deprecated
This 1U mounting panel for 10 inch server racks fits one TP-Link TL-SG105E 5-port, 1G, consumer network switch.
It's designed to have minimum flex while also using little material, so the front of your rack can be supported or even held together with these panels only.
Mounts with regular M6 cage nuts.
| Material | PETG, ABS |
| Layer height | .2mm or any |
| Raft | nope |
| Supports | nope |
| Infill | 20%, gyroid |
| Print surface | powder-coated steel for nice finish ;) |
Your switch should fit into it and stay in place due to friction only (tho your mileage may vary). If the part is to large, add some tape to your switch to make it fit. If the part turns out to be too small, which is highly unlikely, print it again with about +0.5% (at most +1%) scaling. This should be more then enough.