Chenbro RM42300 4U Rack Case ATX PSU Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed version of @YouennTroalic_298578 ATX PSU adapter for the Chenbro RM42300 4U rack case.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 510
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Printed in ABS with my Voron 2.4.
For the heat inserts I used M4 with 5.5mm outer diameter and 4mm in length. The important part is the diameter of the insert as it is possible it won't bond good enough with the plastic with smaller outer diameter inserts. The length should ideally be the same as the the thickness of the plate. Which my 4mm long inserts were not, which made the inserts extend out through the plate's backside. It probably doesn't matter, just a slight annoyance as it doesn't look very nice when the part isn't installed.
Make sure your printer is properly calibrated when printing to avoid any issues when installing the adapter.
If printing in ABS make sure to calculate for shrinkage using your slicers settings as the part is not scaled with shrinkage in mind.