1 / 2
Laser Engraver Mecpow X3 Pro Honeycomb H44 Adapter — zdjęcie 1
1 / 2

Laser Engraver Mecpow X3 Pro Honeycomb H44 Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Laser Engraver Adapter, which helps with placing honeycomb under the laser.

Ocena
5 / 5
Polubienia
20
Pobrania
224
Wydruki
0
Wyświetlenia
976
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

Mecpow X3 Pro Honeycomb adapter

Hello, I've modeled and printed adapter, which helps in placing honeycomb H44 (44 cm x 44 cm) under my Laser Engraver Mecpow X3 Pro. I am not sure if it can fit to other models, but if I get information in future, I will update all information.

After you done printing it, you should print square with measurable offset (I've printed mine with distance 5 mm from left and bottom edge), and then measure it, like on photo:

Here for example we have 5.18 mm instead of 5 mm. This means our bottom offset should be reduced by 5.18 mm - 5.00 mm = 0.18 mm.

 

 

 

 

 

 

 

When we measure both (left and bottom offset) we go in Lightburn to Edit→ Dervice Settings (photo):

 

 

 

 

 

 

 

 

 

 

 

 

And changing Laser offset according to counted values.

(Remember, when you measured values lower than 5 mm offset is positive, when they are bigger than 5 mm - offset will have negative value).

 

 

Tagi