SteamRC Terminator / SAB CNC Ball Link Pliers Retainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Retainer to hold the ball link pliers closed when not in use
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 773
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a retainer for the SteamRC Terminator CNC Ball Link Pliers (HZ051). It also fits the SAB CNC ball link pliers (HM073).
The original plastic retainer broke off while my pliers were in my tool bag. Looking at the original retainer, there was not much material which would have prevented the retainer from breaking off if force was applied to it while the pliers were open, or if someone tried to muscle the pliers open.
This is a modified design and is best used with a small M3 washer to provide additional support for the retainer, as seen in the picture attached.
I used an M3x8 button head screw with the M3 washer. This is notably longer than the original button head screw that came with the pliers. There was a considerable amount of thread locker holding in the original button head screw, so use caution when removing the original screw (heat can be helpful if it won't budge).
I printed using Hatchbox ABS on my Prusa MK4, with a modification to the filament profile to set bridging cooling fan speed to 50% (so supports would break off easily).
Printed with a brim, supports on build plate only, at 0.2mm SPEED with 60% infill out of ABS.