1 / 3
Unterteilungen divider partition MARS Svratka Kleinteilmagazin shelf cabinet 136x275 mm drawer Lade — zdjęcie 1
1 / 3

Unterteilungen divider partition MARS Svratka Kleinteilmagazin shelf cabinet 136x275 mm drawer Lade

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Unterteilungen divider partition MARS Svratka Kleinteilmagazin shelf cabinet 136x275 mm drawer Lade

Ocena
0 / 5
Polubienia
3
Pobrania
28
Wydruki
0
Wyświetlenia
143
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Unterteilungen für die mittelgroßen Laden der MARS Svratka Kleinteilmagazine mit 136 x 275 mm. Die Unterteiler sind leicht konisch. Mit dem Radius nach oben auf die Druckplatte stellen. Gedruckt mit PLA, 0,2mm Schichthöhe und 3 – 4 mm Rand/Brim.

Nachtrag: Ich habe soeben neue Kleinteilregale bekommen und festgestellt, die Nuten in den Schubladen haben nun unten nur mehr 1,5 mm anstatt wie bei den Vorhandenen 1,6 mm => die Trennwände passen nicht ganz hinein. Am einfachsten unten an dem Wänden, nicht über die ganze Länge, nur unten, die Kanten leicht abfeilen, dann passt es wieder.
……………………….
Dividers for the medium-sized drawers of the MARS Svratka small parts magazine with 136 x 275 mm. The dividers are slightly conical. Place them on the pressure plate with the radius facing upwards. Printed with PLA, 0.2 mm layer height and 3 - 4 mm brim.

Addendum: I have just got new small parts shelves and noticed that the grooves in the drawers are now only 1.5 mm at the bottom instead of 1.6 mm like the existing ones => the dividers don't fit completely in. The easiest way is to file the edges slightly at the bottom of the walls, not along the whole length, just at the bottom, then it will fit again.

Tagi