1 / 2
RadioMaster Bandit Micro ExpressLRS Tango 2 foldable antenna mod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tango 2 foldable antenna mod for the RadioMaster Bandit Micro ExpressLRS RF Module.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 638
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
Requirements :
- Bandit Micro ExpressLRS 915MHz RF Module
- Tango 2 Antenna (you can buy it separately on TBS website among others)
- PLA/PETG
- Small file
1 - Assembling the foldable Antenna
- Remove the Tango 2 antenna original hinge : Tap on the first metal axle to get it out, remove the hinge and tap on the second smaller one to get it out as well.
- Assemble it back together using the new 3d printed hinge, the axles go on the same slots as the original. You can snap them back in place using a screwdriver and a small hammer.
2 - Filing
2 parts needs to be filed, the bottom shell with the SMA plastic mounting and the top cover to allow the hinge to spin freely, and to be able to close the module cover.
- Bottom shell :
Print the part beforehand so you can remove just enough material for it to snap in. That's how it needs to look like :
- Top cover :
The circled area had a bit of plastic in the way preventing us from closing the cover with the hinge in place, sand it down like shown and test fit it until it closes properly.
3 - Final assembling
- Run the UFL cable through the “base.stl” and under the pcb, exactly like the SMA was running before.
- slide the “base.stl” in the module, snap the “hinge.stl” in place, plug the ufl back in and you're good to go !
