1 / 4
TP-Link TL-SF1008D Desk Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Conventiently mount your ethernet switch under your desk or on your wall, so it's not in your way and in your sight.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
A little holder for your TP-Link TL-SF1008D eight port ethernet switch. You can conveniently slide the switch in and have it secured by the clip.
Pulling on the ethernet cables only pulls the switch tighter into the mount, not out of it so there is no mechanical load on the clip.
Additional Hardware
- 3x 4mm (or smaller) countersink screws
Print Settings
- Any solid filament should work, PLA might become weak due to the heat.
- Two perimeters should be sufficient, ~10% infill worked well for me.
- No supports are required.
- Recommended print orientation is on the front facing side.
Please consider liking and posting a make if you find this useful 🙂