1 / 14
Magnepan LRS / LRS+  and MG.7 Stands — zdjęcie 1
1 / 14

Magnepan LRS / LRS+ and MG.7 Stands

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Rigid vertical stands for Magnepan LRS / LRS+ and MG.7 speakers. Corrects factory tilt to 90° for improved imaging.

Ocena
5 / 5
Polubienia
7
Pobrania
154
Wydruki
1
Wyświetlenia
598
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Using the existing mounting holes and screws, these stands will hold your Magnepan LRS / LRS+ or MG.7 panels vertical and raise them approximately 2” or 3” (LRS / LRS+ only) depending on which version you choose.

There are some versions with 9mm clearance holes if you decide to add generic aftermarket 8mm threaded spikes.

I used Orcaslicer to slice the part with 10% gyroid infill, 0.24 layer height, and 3 walls for the LRS stands. However, I added modifiers to increase the infill to 50% (rectilinear) around the screw holes to make this area stronger as shown in the picture. Printed with Eryone Black PETG.

NOTE:

  • LRS/LRS+ versions are 38mm wide and have a 2.0" (50.8mm) bracket hole spacing.

  • MG.7 versions are 50mm wide and have a 52mm bracket hole spacing.

  • Please verify mounting hole spacing before printing.

Recommended print settings:

  • Material: PETG or PETG-CF (some users have used ASA)

  • Layer height: 0.24 (or smaller)

  • Infill: 15% gyroid (minimum)

  • Walls: 3 (minimum)

  • Add modifiers around mounting hole areas for increased strength (as shown)

*** 07-2026 Magnepan .7 Versions Added - VERIFIED AND INSTALLED BY USER ***

Please measure and/or test with the fixture before printing. I do not own a set of .7's - I can only rely on communication and photos of these stands in use. Therefore, please measure your mounting holes and/or test with the fixture before printing. Be sure you're comfortable with the stability of the speaker after these are installed - I assume no responsibility for speaker damage.

*** 07-27-2026 Magnepan LRS/LRS+ Larger Versions Added***

Added 2" lift designs that can be printed on 300mm and 350mm for increased stability. 300mm stand shown in picture with comparison to original 220mm stand.

Tagi