Liczymy pasujące modele…
Remixed this plate holder for Bambu Lab P1P/P1S/X1C plates to add HSW pegs for the wall. Also changed the cascade to top to bottom so the plate labels are easy to read while attached to the wall. Printed with PLA+ at a 45 degree angle on…
Remix of neclimdul's HSW Ryobi Hot Glue Gun holder.
Simple HSW mount for the iFixit Pro rollup toolkit storage. Update (11/13/2023): Added a new model that includes a third peg towards the top of the model for stability on the wall. This one will probably require support.
This is a wall mounted holder for the Ryobi EZClean 18/40v handheld pressure washer accessories. I designed this to hold a spray wand(or wand extension), 3 spray heads, the soap sudser, and the angle adapter. And if you have the bucket…
Remix of the blade from GeoPrints13 adding the Triforce engraving.
This is an HSW holster for the Ryobi USB Lithium rotatable driver. Could probably fit other tools as well. But I specifically designed it to hold this driver. I printed with PLA+, but it should work with other filaments as well.
The Aerogardens I have call for 8mL of plant food every so often. I was using a syringe originally but wanted more of a scoop/spoon to pour the plant food into. It comes out to approximately 8mL when filled to the line inside the spoon. I…
The rinse aid plug in my Whirlpool dishwasher had fallen out during a cycle and landed on the heating element and subsequently melted. Decided to try my hand at modeling and printing the plug instead of finding a replacement. I printed my…
Should hold approximately two packages of laundry detergent sheets cut in half, specifically the ones from EarthBreeze.
This is a Pinecil mount for the Ryobi Hobby Station to use it as a heat set insert press. I only have the V2, but from the looks of the V1, it should work as well. You will need to remove the original mount and then mount this one using…
A shelf for the HSW honeycomb wall for storing the Opolar dust blower (or similar blower) and its nozzles.
Will probably need a support for the peg on the back. I put it up higher to offset its center of gravity to be a bit more stable on the wall.
I wanted a wall mount for a rotary scrubbing brush called the Brivennor Electric Spin Scrubber off of Amazon. The mount has a nice snug fit and you can either pop the scrubber in from the front or slide in from the top. The mount has a…
I wanted to make a place to store my Anker Nebula Cosmos projector's remote so that I would be less likely to lose it, so I created this holster and mounted it with mounting tape to my nightstand. It prints upright pretty well with my…
Full parts list can be found on the original version of this model.
This is a remote-control holster for the Motosleep bed height controller. I printed in PETG, but this should print fine with PLA as well. Should be printed upright. For some reason it's exporting the model lying on its back. I printed two…
I got the HOTO Laser Distance measurer and unfortunately it didn't come with any sort of protective casing for the device and lens. I whipped up this quick sock to fit over the device. I printed it on my Bambu Lab P1S with TPU 95A with a…
I still had the mounting hardware for my old weather station installed. The mounting pole outer diameter of the old one is around around 29.5mm ish. The inner diameter on this remixed version of the pole adapter is around 29.6 in the…
To wszystkie aktualnie dostępne wyniki.
